album:August_2026

Screw reverser assembly with latch down. - Erle Ford August 2026

Screw reverser assembly with latch up. - Erle Ford August 2026

Connecting rod on the hydraulic press to add the slight bend required. - Andrew Nelms August 2026

Trial fitting of the connecting rod during bending operations - Andrew Nelms August 2026

It's always a nice excuse to get the C2 out in the sun. It was much eaiser to get the C2 nearer the hydraulic press than it was to move the hydraulic press to the C2. The mountain shown just in front of the chimney is Yr Wyddfa (Snowdon in English) - Andrew Nelms August 2026

Andrew started making the big end bearing cover plates. These are not finished but were at a stage where they could be used to position the connecting rods to allow trial fitting of the connecting rods onto the crank pins. - Andrew Nelms August 2026

Combination Lever - Andrew Nelms August 2026

Valve gland bronzes turned at fitted by Jack - Andrew Nelms August 2026

I never get bored of the view from Boston Lodge! - Andrew Nelms, August 2026